R30-A Concrete Sealer Datasheet
R30-A Concrete Sealer
Concrete Sealer R30/A Concrete Sealer primes, protects and waterproofs. R30/A is a high performance treatment for garage, utility floors workshops and all internal concrete surfaces. The unique formulation stabilises the surface, prevents dusting, repels dirt, oil, fuel stains, and can be used to prime treated concrete prior to painting.
R30/A Concrete Sealer primes, protects and waterproofs. R30/A is a high
performance treatment for garage, utility floors workshops and all internal concrete
surfaces.
The unique formulation stabilises the surface, prevents dusting, repels dirt, oil, fuel stains, and can be used to prime treated concrete prior to painting.
The unique formulation stabilises the surface, prevents dusting, repels dirt, oil, fuel stains, and can be used to prime treated concrete prior to painting.
- R30/a is supplied ready to use and should not be diluted. Shake container before use. Ensure surface is thoroughly dry and dust free before application. (applying to a damp surface may cause whitening.)
- Do not pour directly on to surface. Apply with a brush, long pile roller, or low pressure sprayer.
- Apply an even coat avoiding runs, drips or puddling by removing excess product from the surface.
- Use an emulsion brush to finish the edges.
- For porous surfaces, apply 2 coats, the second within 2 hours of the first. For dense surfaces a single coat is normally sufficient.
New concrete should be allowed to cure for 30 days before application. This
product is not suitable for non porous surfaces e.g. quarry tiles, engineering brick,
polished or glazed surfaces.
This product is not suitable if surfaces have been previously treated with a silicone or stearate based water repellent. Do not apply if rain is expected within 4 hours or before the surface is completely dry.
Do not apply during rain or frost and when surface air temperature is <10ºc and > 25c.
Keep pets away until surface is fully dry
This product is not suitable if surfaces have been previously treated with a silicone or stearate based water repellent. Do not apply if rain is expected within 4 hours or before the surface is completely dry.
Do not apply during rain or frost and when surface air temperature is <10ºc and > 25c.
Keep pets away until surface is fully dry
Always test a small inconspicuous
area before use, to ensure surface
compatibility, performance and finish
is acceptable.
Remove surface contamination. Surface should be clean, free from dust, dirt, oil, efflorescence, organic growth, coatings and water sealers.
All algae and mould should be treated and removed using R06 Algae Remover.
Remove surface contamination. Surface should be clean, free from dust, dirt, oil, efflorescence, organic growth, coatings and water sealers.
All algae and mould should be treated and removed using R06 Algae Remover.
