R28-10 WATERSEAL for Wood Datasheet
R28-10 WATERSEAL for Wood
Waterseal for Wood A high performance, penetrating, water repellent sealer for porous & untreated wood. Formulated using the latest technology to give outstanding results. Provides a hard wearing invisible, protective seal against water, oil, stains, efflorescence and much more on both horizontal and vertical surfaces
Waterseal for Wood is considered to be the ultimate protection against water and
dirt ingress, prolonging the life of wooden substrates by up to 5x there usual life cycle.
It is suitable for use in all settings, around the home & DIY projects are made easy by this simple application, whilst industrial and larger areas can be treated allowing a heard wearing & easy to maintain seal.
Dirt Defence water wrap technology means that active ingredients work together to bond tightly to pores of the wood, creating a strong chain cross linked bonds to instantly repel water, it enables each droplet of water, to be the instantly pushed to the surface of the wood, preventing all forms of dirt and water ingress.
It is suitable for use in all settings, around the home & DIY projects are made easy by this simple application, whilst industrial and larger areas can be treated allowing a heard wearing & easy to maintain seal.
Dirt Defence water wrap technology means that active ingredients work together to bond tightly to pores of the wood, creating a strong chain cross linked bonds to instantly repel water, it enables each droplet of water, to be the instantly pushed to the surface of the wood, preventing all forms of dirt and water ingress.
Apply with a low pressure spray or brush from bottom to top on vertical surfaces,
at a spread rate of 4-5m per litre. Ensure an even, wet coat to the point of
saturation.
Apply an even wet on wet coat to the point of saturation, once the first coat starts to soak in, allowing for deeper penetration into the substrate. Do not allow the product to dry in between applications.
Avoid runs drips or puddling by removing excess product from the surface. Allow to cure for 2 hours - 24 hours before subjecting to heavy use on horizontal surfaces.
Apply an even wet on wet coat to the point of saturation, once the first coat starts to soak in, allowing for deeper penetration into the substrate. Do not allow the product to dry in between applications.
Avoid runs drips or puddling by removing excess product from the surface. Allow to cure for 2 hours - 24 hours before subjecting to heavy use on horizontal surfaces.
Remove surface contamination and ensure all algae and mould have been treated
and removed prior application. Surface must be completely dry before application.
Always test on a small hidden portion of the surface to be cleaned to check
compatibility and performance before commencing with the whole area
Do NOT apply to hot surfaces or in strong direct sunlight. DO NOT allow the
product to dry in between applications. Not suitable for non porous substrates.
