R10 Enviromose Pro Grade Paint Stripper Datasheet
R10 Enviromose Pro Grade Paint Stripper
A fast acting and safer to use, water based double strength paint remover. Suitable for use on a wide range of surfaces, removes sealers and coatings safely and effectively without damaging the surface.
Always test an inconspicuous area before use to ensure the compatibility
and finished result is acceptable. Ensure the surface(s) to be stripped are dry
before applying the Enviromose Pro Grade Paintstripper. Protection should
be provided for floor coatings that you do not wish to remove or any surface
that may be damaged by the remover i.e. perspex, plastics, rubber
- Cover the top with a cloth during opening to avoid splashes.
- Layer a generous, even coat of enviromose onto the surface to be stripped.
- Apply with a suitable clean brush or airless spray (rollers can be used for light coatings) do not brush out
- Leave for approximately 2 hours and apply a second generous coat. (on less than five layers of paint or varnish, a second coat may not be necessary).
- After the product has penetrated the substrate (up to 24 hours) scrape off with suitable scrapers, leaving surface as clean as possible.
- Rinse clean with cold water containing detergent and a stainless steel only.
