PRODUCT CODE: R10
Enviromose Pro
OVERVIEW
Removes sealers and coatings safely and effectively without
damaging the surface. Strips a wide variety of surfaces and
coatings including:
Paint & Varnish
Artex
Stains & Lacquer
Graffiti
Carpet adhesive residues from floors
BENEFITS
For internal & external use
Safer and easy to use
Water based and non-flammable
Non-corrosive, non-ozone depleting
Extra strong for tougher finishes
Fast acting
Eco-friendly
Low VOC
PRECAUTIONS FOR USE
For Health & Safety instructions, first aid measures,
spillages and disposal instructions, see separate Health &
Safety Data Sheet (MSDS)
SURFACE PREPERATION
Always test an inconspicuous area before use to ensure
the compatibility and finished result is acceptable. Ensure
the surface(s) to be stripped are dry before applying the
Enviromose Paintstripper. Protection should be provided
for floor coatings that you do not wish to remover or any
surface that may be damaged by the remover i.e. perspex,
plastics, rubber etc.
STORAGE
Keep out of reach of children
Keep in a dry place between 5ºc and 30ºc in the original
container.
GUIDE OF STRIPPING TIMES
Varnish: up to 60 minutes
Two pack varnish: up to 3 Hours
Heavy multi-layered paint: 120 minutes - Overnight
Two pack lacquer: up to 24 Hours
Artex: 1 - 4 Hours
CLEANING OF EQUIPMENT
Remove as much excess product as possible and clean
tools and equipment immediately after use with soapy
water.
PRODUCT CHARACTERISTICS
Colour White
Odour Barely Perceptible
Form Liquid
Specific Gravity @
25ºc
1.01
PH 4/4.5
Shelf Life 24 months from the date of
manufacture in the original
unopened container
Application
Temperatures
Min 5ºc, max 30ºc
Coverage 1 litre will strip 1-3 m²
dependant on thickness and
amount of layers / coatings to
be stripped
APPLICATION
Cover the top with a cloth during opening to avoid
splashes.
Layer a generous, even coat onto the surface to be
stripped.
Apply with a suitable clean brush or airless spray. Do not
brush out
Leave for approximately 2 hours and apply a second
generous coat. (On less than five layers of Paint or
Varnish, a second coat may not be necessary).
After the product has penetrated the substrate (up to 24
hours) scrape off with a suitable scraper, leaving surface
as clean as possible.
Rinse clean with cold water containing detergent and a
stainless steel scourer, leave to dry. Never use steel wool
- stainless steel only.
For heavily contaminated surfaces such as lintels, ledges,
old masonry and other substates that are often heavily
coated, it is necessary to apply up to 1m² per litre of
paint remover.
Cover with thin plastic such as cling film or bin liners,
proceed to tape the edges.
Leave for a minimum of 24 hours, scrape off excess and
rinse clean with cold water containing detergent and a
stainless steel scourer.
© Chemicals Limited, PO Box 88, Southport, Merseyside PR8 5LH. Tel: 01704 880800. BS EN ISO 9001:2008 Cert No: 4146865