R10-B1 PARAMOSE R10/B1 Datasheet

Always test an inconspicuous area before use to ensure the compatibility and finished result is acceptable. Protection should be provided for floor coatings that you do not wish to remove or any surface that may be damaged by i.e. perspex, plastics, rubber etc.

• Graffiti: 5 minutes - 2 hours
• Varnish: 10 - 30 minutes
• Paint: 5 - 30 minutes
• Two pack varnish: 15 - 90 minutes
• Heavy multi-layered paint: 45 minutes 12 hours
• Two pack lacquer: 15 minutes - 12 hours
• Artex: 30 minutes - 2 hours

Paramose R10/B1 is supplied ready to use and should not be diluted. Ensure the surface is completely dry before application. Cover the top with a cloth during opening to avoid splashes.

Layer a generous, even coat onto the surface using a clean brush or airless spray (rollers can be used for light coatings) DO NOT BRUSH OUT Leave for the recommended timing dependant on the stripping guide and apply a second generous coat. (On less than five layers of Paint or Varnish, a second coat may not be necessary). After the product has penetrated the substrate (up to 24 hours) scrape off with suitable scrapers, leaving surface as clean as possible.

Rinse clean with cold water containing detergent and a stainless steel scourer, leave to dry. Never use steel wool - stainless steel only.

For Health & Safety instructions, first aid measures, spillages and disposal instructions, see separate Health & Safety Data Sheet (MSDS).

Remove as much excess product as possible and clean tools and equipment immediately after use with soapy water.

• Graffiti
• Paint & varnish
• Artex
• Stains & lacquer
• Carpet adhesive residues from floors

• Safer and easy to use
• Water based and non-flammable
• Non-corrosive, non-ozone depleting
• Extra strong for tougher finishes
• Fast acting
• Eco-friendly
• Low voc

Keep out of reach of children Keep in a dry place between 5c and 30c in the original container.

Colour	White
Odour	Barely Perceptible
Form	Liquid
PH	Approx. 4.5 - 5
Specific Gravity @ 25c	1.01
Shelf Life	24 Months from the date of manufacture in the original unopened container -protect from frost
Application Temperatures	Minimum +5c Maximum 30c
Coverage	1 litre will strip 1m² dependant on thickness and amount of layers / coatings to be stripped